Z Compression Correction? - Form 3/3+ - Formlabs Community Forum

$ 19.00

5 (407) In stock

I’m printing directly on the build platform (V2) and am having trouble getting the height of the parts close to size. I started with the default settings and my part came out 0.9mm too high. I adjusted the z compression correction to 0.0mm and my part is still 0.2mm too high. How to I adjust it further to compensate? Also, how do I avoid the edge highlighted in the second image where the part sits on the build plate? Thanks. (I’m printing directly on the platform for speed of print and surfac

marrs

PDF) Characterization of mechanical stiffness using additive manufacturing and finite element analysis: potential tool for bone health assessment

Prints resolution/distortion in area of supports and surfaces facing platform - Form 3/3+ - Formlabs Community Forum

Uncategorized

PDF) A Development of New Material for 4D Printing and the Material Properties Comparison between the Conventional and Stereolithography Polymerised NVCL Hydrogels

DDL2021 Digital Proceedings by info-ddl-conference - Issuu

Z-Compression Correction question - General Discussion - Formlabs Community Forum

Formlab 3 precision is worst than FDM - Form 3/3+ - Formlabs Community Forum

Polymers, Free Full-Text

The RAPID 2013 Conference & Exposition Directory - Society of

Resin pooling on top side of parts adding 0.5 mm to height - Form 3/3+ - Formlabs Community Forum

First Layher Exceeding base Problem - Support & Troubleshooting - Formlabs Community Forum

Advances in 3D bioprinting technology for functional corneal reconstruction and regeneration. - Abstract - Europe PMC