First Layer Issues - Creality K1 Max - 3D Printing Space

I’ve been all over the place with this machine so far, and this is where I am now. Any suggestions as to what direction I should be heading are appreciated. Rooted K1 Max/Orcaslicer/Duramic PLA/0.4mm nozzle @230⁰/speed: 50mm/retraction: 0.5mm @ 60mm second My starting flow ratio is 0.99 and my line width was at 0.34mm. I am playing with my Z offset and flow rate on the Fluidd interface as I go with these. The filament is dry. The flow settings shown on the pic are relative to the starting po

First Layer Issues - Creality K1 Max - 3D Printing Space

Creality K1 Max - 3DJake International

First layer issue with K1 Max : r/crealityk1

K1 not doing first layer good anymore : r/Creality

Refurbished】Creality K1 Max 3D Printer 600mm/s High Speed Auto Leveling Smar

Creality official K1 and K1 Max community

K1 Max reaches 600mm/s* in only 0.03s based on 20000mm/s² acceleration. It can be as productive as several 3D printers together. K1 Max: 600mm/s

K1 Max AI Fast 3D Printer

Creality K1 / K1C / K1 Max, I have a probably beginner's question: Today I printed the same file one after the other for the 5th time

Creality K1 Max - 3DJake International

Fix Your 3D Printer First Layer Issues, Z Offset Calibration

Teaching Tech 3D Printer Calibration

print quality - What is causing 'droplets' on first layer? - 3D Printing Stack Exchange

First/second layer pattern magic by Filagram, Download free STL model

3D Printing Quality Problems: Why is the First Layer Rough?

P1p first layer is no longer as good as before - Troubleshooting