Thermistor 100K, Crimped w/ Cables – UltiMachine

$ 2.50

4.8 (575) In stock

This thermistor is used for measuring the temperature of the RepRap extruder. The thermistor has been crimped with wire leads and a 2-pin male latch housing. The matching cable has been housed with a 2-pin female latch housing on one end, and a 2-pin connector labeled "thermistor" on the other end. The default thermis

NTC 100K ohm B3950 Thermistor Cartridge

Upgrade from the original ordinary temperature probe directly exposed temperature measurement to resistance package temperature measurement.

Thermistor NTC 100K Wire 2m for 3D Printer

6*20mm 12V 40W 100K NTC Thermistor Wire 150mm PH2.0-2PIN Terminal for 3D Printer

OIIKI 5 PCS HT-NTC 100K Temperature Thermistor 3D Printer Parts, Sensor High Temperature +260 Degrees 2 Pins Thermistor Compatible for Reprap 3D Printer : Industrial & Scientific

Acinkeety EBB SB2209 CAN with Pre-Crimped 30-Pin Wire NTC100K Thermistor for Voron StealthBurner 3D Printer Hotend Klipper SB2240 EBB SB2209 CAN with Pre-Crimped 30-Pin Wire High-Performance 32-bit : Industrial & Scientific

LulzBot Parts

LulzBot Parts

Thermistor 100K NTC B3950 M3 Screw-In Style

✔️Upgrade HT-NTC100K Thermistor: package temperature measurement. Head diameter: 3mm, Head length: 15mm ✔️The temperature measurement: -50 °C ~ +350

WINSINN HT-NTC100K Thermistor Sensor, Ender 3 v2 Upgrade 3x15 3950 XH2.54 2Pin, Compatible with Ender 3 5 Pro CR6 CR10 Series 3D Printer Hotend (Pack

All – Page 3 – UltiMachine

Thermistor 100K NTC B3950 M3 Screw-In Style