P1p first layer is no longer as good as before - Troubleshooting - Bambu Lab Community Forum
4.7 (404) In stock
Hey guys so since I did the last update to be at the latest firmware my first layer is lost it’s textured finish. I tried reverting to the previous firmware and still same issue. Support asked to to check the belt tension, recalibrate and manual level. Now I’m found calibration on the K value but the one value that looks best has problems with adhesion and one corner will lift lol, if I change it back to default it will print with no lift lol. Any other ideas from the group as to what I should t
Underextrusion issues in the first layers
Has anyone had direct experience use JB Weld on metal to PLA
P1p first layer issues- not sure on the cause : r/BambuLab
Bambu Studio Fine Tuning: Tips And Tricks For X1 And P1P
Bambu lab hardware - Bambu Lab P1 Series - Bambu Lab Community Forum, g1 f1800
What changed? Not the smooth first layer it used to be, same file I've printed 50 times. P1P. : r/BambuLab
Bambu Lab P1P/X1C full plate first layer test print by stevensaero, Download free STL model
P1p first layer is no longer as good as before - Troubleshooting - Bambu Lab Community Forum
Hydra AMS for Bambu Lab X1 and P1P - Modification enables larger filament selection
BAMBU LAB P1P UNBOXING & TEST PRINTS
P1p first layer issues- not sure on the cause : r/BambuLab
Releases · bambulab/BambuStudio
Need Help with Bambulab P1P top Layer printing Issues (Pillow.) - Troubleshooting - Bambu Lab Community Forum
Has anyone had direct experience use JB Weld on metal to PLA
This printer (P1S) continues to amaze me : r/BambuLab
Prusa First Layer Calibration: All You Need to Know
adhesion - FDM printer first layer infill swell upward - 3D Printing Stack Exchange